![]() In most cases, their diagrams are right from the factory manuals. They include wiring diagrams and technical service bulletins. Get the BEST auto repair information and are professional-grade shop manuals-period. Idle speed = 650 ± 50 rpm (in P or N position) 20 seconds until the MIL stops blinking and turned ON.Ĩ) Fully release the accelerator pedal within 3 seconds after the MIL turned ON.ġ1) Rev up the engine two or three times and make sure that idle speed and ignition timing are within the specifications. Repeat the following procedure quickly five times within 5 seconds.ħ) Wait 7 seconds, fully depress the accelerator pedal and keep it down for approx. Turn ignition switch OFF and wait at least 10 seconds.Ģ) Perform the Throttle Valve Closed Position Learning Procedureĭuring the last 10-second period, listen to the throttle body to make sure you hear it moving.ģ) Start the engine and let it run under the temp gauge is in the normal range.Ĥ) Turn ignition switch OFF and wait at least 10 seconds.ĥ) With your foot off the accelerator pedal, turn the ignition switch ON and wait 3 seconds.Ħ) Then perform this procedure with the engine off, key in ON position. Turn ignition switch OFF and wait at least 10 seconds Turn ignition switch ON and wait at least 2 seconds ![]() This procedure tells the ECU what voltages to expect when your foot is off the pedal Transmission must be warmed up (driven for at least 10 minutes.) Nissan Throttle Body Relearn Procedureġ) Perform the Accelerator Pedal Released Learning procedure. The steering wheel must be in the straight ahead position. Each of these conditions must be met before attempting a Nissan Throttle Body Relearn Procedure:īattery voltage must be above 12.9V with engine running at idleĮngine coolant temperature must be within 158 – 212 FĪll electrical accessories OFF (Air conditioner, headlamp, rear window defogger) ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |